Rigol MSO/DS2000A Series Instrukcja Użytkownika Pobierz pdf (Strona 166)

RIGOL Chapter 6 MATH and Measurements

6-30 MSO2000A/DS2000A User’s Guide

Track Mode

In this mode, one or two cursors will appear. You can adjust the two cursors (cursor

A and cursor B) to measure the X and Y values on two different sources respectively.

The points being measured on cursor A and B are marked by an orange rectangle

and rhombus respectively. When the cursors are moved horizontally, the marks will

position on the waveform automatically. When the waveform is expanded or

compressed horizontally, the marks will track the points being marked at the last

adjustment of the cursors.

Press Cursor  Mode  “Track” to turn on the cursor track function and the

measurement results will be displayed at the upper left corner of the screen in the

following mode.

 A->X: the X value at cursor A. The X value takes the trigger position as reference

and “s” or “Hz” (when measuring FFT waveform) as its unit.

 A->Y: the Y value at cursor A. The Y value takes the channel GND as reference

and use the same unit as the current source.

 B->X: the X value at cursor B. The X value takes the trigger position as reference

and “s” or “Hz” (when measuring FFT waveform) as its unit.

 B->Y: the Y value at cursor B. The Y value takes the channel GND as reference

and use the same unit as the current source.

 △X: the horizontal difference between cursor A and B.

 1/△X: the reciprocal of the horizontal difference between cursor A and B.

 △Y: the vertical difference between cursor A and B.

1. Select Measurement Source

Press Cursor A or Cursor B to select the waveform of analog channels (CH1 or

CH2) or math operation results (MATH) as the measurement source of cursor A

or cursor B (only channels enabled are available). You can also select “None”,

1 2 ... 161 162 163 164 165 166 167 168 169 170 171 ... 316 317

Brak uwag

Rigol MSO/DS2000A Series Instrukcja Użytkownika Strona 166