Rigol DS2000 Series Dokumentacja Pobierz pdf (Strona 23)

RIGOL

DS2000 Quick Guide

Probe Compensation

When the probes are used for the first time, you should compensate the probes to

match the input channels of the oscilloscope. Non-compensated or poorly

compensated probes may cause measurement inaccuracy and error. The probe

compensation procedures are as follows:

1. Perform step 1, 2, 3 and 4 of “Function Inspection”.

2. Check the displayed waveforms and compare them with the following figures.

Figure 8 Probe Compensation

3. Use a nonmetallic driver to adjust the low-frequency compensation adjustment

hole on the probe until the displayed waveform is as the “Correctly

compensated” in the figure above.

Over compensated Perfectly compensated Under compensated

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 45 46

Brak uwag

Rigol DS2000 Series Dokumentacja Strona 23